LED Pod
BackThis project is being designed for use on my motorcycle. I am building four of them and the cost will be less than one commercially available alternative. All that is requires is some basic soldering skills, measuring, and drilling. When drilling plastic always use a small bit and move up bit sizes slowly to prevent the plastic from cracking.
Parts List::
| Parts: | Prices: |
| Clear 2x1x1/2 Inch Box | 3 for $1.00 at hobby lobby |
| Six 5mm leds | Depends on source |
| Two 220 Ohm resistors per box | Depends on source |
Schematic:
Images:
 |
 |
 |
